Welcome to TOYZUKI'S FABRICATION

The V2.5 Chassis kit is exactly the same as the V2 other than the transfercase. The motor mount parts stack in a different order, which makes the motor mount a pass through instead of a reduction box....

The V2 chassis kit is for the Axial scx10.2 with the new 5 gear transmission . The Toyzuki version 2 moves the motor closer to the frame than the old version 1 to free up some driveline clearance for the...

This transfercase is designed to go behind any of the Toyzuki motor mounts and has 44% overdrive. It has a 2.6:1 ratio to the rear axle and a 1.8:1 ratio to the front axle. The mounting bolt pattern is...

The VS410 motor mount was designed to fit the Vanquish VS410. The offset diff of the 410 allows for more room to drop the motor. The motor plate has 4 different height settings so you can decide how low...

The V1 Motor Mount was designed to run in the V1 chassis. It moves the motor lower in the chassis and forward like all Toyzuki motor mounts. It is a bolt in option for the Brazin Scale chassis as well....

This kit mounts the servo and servo winch in the V1 chassis. The panhard mount and axle truss are designed for the Axial AX/SCX10 axles. There are multiple holes in the axle truss to mount your panhard...

The V1 transfer case was designed to go behind any of the Toyzuki motor mounts with a 2.6:1 ratio. It uses the top and bottom gears, bearings, and shafts from your stock 3 gear scx10 transmission. Removing...

This CMS kit is the same as the V1 CMS kit, but without the SCX10 axle truss. It mounts the steering servo and servo winch, and also provides a panhard mount for the chassis. The variety of axles used...

The V3 motor Mount is designed specifically for the V3 chassis and Axles with an offset diff. The motor mount can be assembled with the motor on either side of the chassis like all of the ToyZuki G10 motor...

This servo mount is for the v2 and v2.5 chassis. It allows you to mount the steering servo and the winch servo vertically. This is not the standard servo mount that comes in the kits.

This is the standard servo mount that comes with the v2 and v2.5 kits. It mounts the steering servo vertically, and an internal spool servo winch horizontally. You can also mount a servo winch in the rear...

These are replacement chassis rails for v2 and v2.5. This is not a full kit.